Filter Results By:
Products
Applications
Manufacturers
Gas
1) fills any space it's contained in and is amorphous. 2) liquid fuel powering vehicles.
See Also: Dissolved Gas, Gasoline, Ammonia
- Virginia Panel Corporation
product
Enclosure Accessory Kit, Gas Spring for Sloped Enclosure
410114133
The sloped enclosures come capable of having a Gas Spring accessory installed on the left, right or both sides of the enclosure. The enclosure comes standard with one Gas Spring accessory on the right side.
-
product
Gas Metering Device- Commercial
U10
The U10 light commercial gas meter is rated to 10.0 m³/hr of gas @ 125 Pascal loss across the meter with a high level of accuracy due to the meters large cyclic capacity, radial valve covers and a magnetic drive which all combine to give superior accuracy retention and stability throughout the life of the meter.
-
product
Gas Infared Camera
TI 330+
TI330+ is with a cooled detector(T2SL, NETD<25mK) to detect gas leaks and pinpoint the gas leaks location accurately, also offers temperature measurement. It is a multifunctional device for gas leakage detection and thermography applications.
-
product
Gas Filters
WITT gas filters enable the finest filtering of impurities in technical gases such as acetylene, argon., oxygen, hydrogen, methane, carbon dioxide, helium, compressed air and ethylene. They thus protect downstream equipment and systems. Some gas filters are also referred to as gas cleaners.
-
product
Flue Gas Analyzer
IMR 1400C
IMR Environmental Equipment, Inc.
The IMR 1400C is a portable, continuous measuring flue gas analysis instrument housed in an aluminum case.
-
product
Gas Pressure Manometer
1213
Provide visual indication of pressure with the Series 1213 Gas Pressure Manometer. Designed for use with natural gas, the manometer can also be used to monitor any compatible gases up to 15 inches of water column
-
product
Air Quality / Gas / Flow Sensors
Panasonic Industrial Devices Sales Company of America
Panasonic offers compact, high sensitivity Air Quality, Gas and Flow Sensors for use in equipment or automation processes. Designed for air quality / IAQ monitors and home appliances, the Laser Type PM (Particulate Matter) Sensor can detect dust particles down to the 0.3 m size.
-
product
Wide Range Pressure Insensitive Mass Flow Module
D700WR
The D700WR installs a new restrictor designed specifically for a wide range control application with high accuracy performance based on the CRITERION™ technology. D700WR can control flow rate down to 0.1% of full scale range which helps users to optimize the flexibility of gas delivery system. For example, if the system installs multiple MFCs for high and low flow rate control, users can reduce the number of MFCs and use another MFC in the same position for a different purpose.
-
product
Calcmet Software
All Gasmet FTIR analyzers are supplied with Calcmet software. The software collects, stores and visualizes the FTIR spectra of the sample gas and analyzes the concentrations of gas components. Quick and accurate results in easy-to-use package.
-
product
Trace-Level Photometric Ozone Calibrator
Model T703U
Teledyne Advanced Pollution Instrumentation
The Model T703U is a microprocessor controlled ozone calibrator for precision gas analyzers. Expanded ozone audit levels have created a need for precise ozone calibration well below the capabilities of standard calibrators. The Model T703U is designed to meet the requirements of ultra-low ozone production.In addition to a high range with similar performance to the Model T703, the Model T703U has the capability to generate ozone in a low range, or "fractional" mode, for producing ozone levels down to 3 ppb, with exceptional accuracy. Flow rate and lamp intensity are adjusted to deliver a specified ozone concentration by volume. The temperature and pressure compensated photometer, identical to that of the Model T400 ozone analyzer, provides feedback control of the UV lamp intensity, assuring stable ozone output. A nearly unlimited number of calibration sequences may be programmed into the non-volatile memory of the T703U, covering time periods up to a year.
-
product
Fast Response Gas Detector
Leaksurveyor
Teledyne Gas & Flame Detection
The GMI Leaksurveyor combines quality, ruggedness and advanced Technology in a user friendly, portable gas detector. The integral fast response and high sensitivity semiconductor sensor enables leakage surveys to be performed and distribution leaks to be quickly found.
-
product
Dynamic Gas Analyser
ExQ
The Hiden ExQ quantitative gas analyser is a new multi-featured and compact mass spectrometer system providing continuous on-line analysis of dynamic gas streams at pressures from sub-atmospheric up to 30 bar, the fully integrated system now being configurable both for benchtop and for rack-mounting operation. Connection to the process is via a flexible heated inert capillary line with a sample consumption rate less than 10 mL/minute and a response time of less than 300 milliseconds at pressures near atmosphere. The comprehensive range of process interface options enables adaptation of the system to accommodate analysis of up to 16 individual process streams, and adaptors are available for direct connection of the system to most standard TGA/TA instruments. External process data, sample temperature or mass for example, can be imported for combined integration and presentation with the mass spectral data.
-
-
product
Multi Channel Detectors
Dual, triple, quad and eight channel infrared detectors for gas analysis and flame detection sensors where more than one element or event is to be detected.
-
product
Quick Α Digital Scintillation Actinography
FFA-2
FFA-2 quick α digital scintillation actinography is designed to measure α ray intensity in soil sample or on α cards for the purpose of locating geological structure, such as concealed fault, fissure, fracture zone, underground water reservoir, and the tectonic cloud of the natural gas and oil. It can also be used to engineering geology exploration, the deep uranium mineral ore, regional radon detection (environmental protection detection), and trace original gold vein.
-
product
High Voltage Isolation Switch Contact Pressure Tester
WA1401
Wuhan Sangao Electrical Test Installations Limit Co.
Isolation switch is the high voltage switch equipment, it was large and frequently use in power system . The outdoor isolating switch is the only completely exposed in the atmospheric environment electrical equipment, It is also a electrical equipment affected by climatic conditions influence the most direct and most serious. The operating conditions is relatively poor, It is easy to generate fault of mechanical or electrical. Especially the finger contact part is easy to be affected by rain, dust and harmful gas invasion, resulting in poor contact caused fever, provide the spring with contact pressure due to heating and annealing for reducing the pressure, so that more cause finger heat form vicious spiral eventually burn out finger accident. In maintenance often only pay attention to replace the obvious failure and fracture of spring, but spring to reduce the pressure can not judge and replacement, so again in the operation, each finger current distribution by the pressure difference, The greater the difference between the current distribution is not uniform, long-term operation will occur is bad and the overheating. Fever finger will be vicious spiral, a finger contact bad will spread over the entire bad contact. At the same time, there are a lot of isolating switch contact pressure can be adjusted, if in maintenance adjustment pressure is not enough or each finger to adjust the pressure difference will also appear afore-mentioned phenomena.
-
product
Lightning Surge Generator
CDN-5809
Shanghai Sanki Electronic Industries Co., Ltd.
CDN-5809 signal line/data line coupling decoupling network, unshielded asymmetric communication line suitable for surge pulses and ringing wave pulses, designed according to Figure 9 of the new standard IEC61000-4-5.Ed3. It also satisfies vibration Figure 9 of the ring wave standard IEC61000-4-12Ed2 requires unshielded asymmetry. According to the characteristics of the line, the pulse coupling can be realized by gas discharge tube, capacitor, diode and other different methods.
-
product
Gas Monitor System
Henan Bosean Electronic CO.,Ltd.
Used to detect combustible, flammable and toxic gases, and oxygen depletion.
-
-
product
CGS500 Combustible Gas Sensor
The Monicon CGS500 thermocatalytic combustible gas sensor has been designed to measure concentrations of combustible gases in the range 0-100% LEL. The CGS500 is fitted in an EExe certified junction box.
-
product
Gas Permeability Testers
Gas Permeability Tester (Gas Transmission Rate Tester) is based on the differential pressure method and is professionally applicable to the determination of gas transmission rate of plastic films, composite films, high barrier materials, sheeting, metal foils, rubber, tires and permeable membrane.
-
product
Multiple Gas Transformer DGA
MULTITRANS
The MULTITRANS is an 8-gas on-line transformer DGA monitoring unit designed to monitor a bank of three single-phase transformers in close proximity. Based on the same core technology as the highly successful TRANSFIX the MULTITRANS measures all significant fault gases (in ppm) as outlined by international standards as well as moisture in oil (%RH & ppm).
-
product
Tracer Gas Leak Test Systems
Tracer gas leak testing is a simple and highly-efficient method of leak detection that provides high sensitivity as well as increased accuracy and repeatability. This method is used for testing parts with very low leak rates that are outside the range for conventional air-flow pressure decay and mass flow, or to replace bubble test methods. Tracer gas testing uses escaping tracer gas to identify micro-leaks in the range of 1x10-4 to 10-9 scc/s.
-
product
Continuous Gas Analyzer
CT5400
Multi-component continuous gas analyzer combines QCL and TDL technologies in a single rack mount enclosure to measure process gas and monitor emissions from sub ppm to % levels. The CT5400 is ideal for measuring NOx, SO2, CO, CO2, CH 4, NH3, O2, HCl and other combustion gases identified as pollutants, ozone depleting, or responsible for global warming.
-
product
GAS Detector
6601
Peaceful Thriving Enterprise Co Ltd
This detector is design to detect the concentration of flammable gas (natural gas [Methane], propane, butane, liquefied petroleum gas, liquefied natural gas). The concentration of GAS will be indicated by LED and buzzer voice. It's a helpful appliance for home, room and factory detection.
-
product
Digital Pressure Sensor (For Gas)
DP-0
Panasonic Industrial Devices Sales Company of America
With the DP-0 Series, Panasonic launches a new digital Pressure Sensor which focuses on very simple operation. This Pressure Sensor has been developed especially for the electrical and electronic, semiconductor and auto-assembly industry, but can be also used in the biomedical industry (laboratory automation), where simplicity and performance are key objectives.Compared to the DP-100 series, which features a multitude of functions, the DP-0 Series has been designed to make configuration fast and simple.
-
product
Pressure Loss Test Bench For Measuring Unit Of Gas Meter
Bofa Instrument & Equipment Co., Ltd
Pressure loss test bench for gas meter measuring unit of gas meter is ideal device to check pressure loss of measuring unit of gas meter, the test bench is designed as per gas meter production crafts and testing requirements, adopting imported pneumatic components and accurate sensors. It is an ideal testing device to be used in production line for gas meter manufacturer
-
product
Gas Detectors
Inspecting and detecting gas leaks in industrial and/or commercial settings is an important element of maintaining security. GAOTek gas detectors are compact, lightweight, and easy to carry. When you choose an industrial-grade GAOTek gas detector, know that you can rely on it to deliver accurate information with real-time readings on how much the concerned gases are in the air, ensuring the safety of your premises and anyone occupying the space is upheld.
-
product
Cryocoolers
DS Mini
The DS Mini cryocooler brings gas bearing technology to the mini-cryocooler market. The DS (Dual Split) features dual-opposed pressure wave generator pistons and a split cold head to reduce exported vibration and acoustic noise. The optional passive balancer will further reduce cold head vibration for sensitive applications. Both the cold head and wave generator can be mounted in any orientation. Using gas bearings in the pistons as well as the displacer, the DS maintains the core technologies of the well-established integral CryoTel MT, CT and GT cryocoolers. The DS Mini represents an advantage over flexure bearings due to its higher power density, while still offering a longer lifetime compared to rotary compressors and contact seals.
-
product
CRDS Gas Analyzers
Based on absorption spectroscopy, our Tiger Optics Cavity Ring-Down Spectroscopy (CRDS) works by attuning light rays to the unique molecular fingerprint of the sample species. By measuring the time, it takes the light to fade or “ring-down”, you receive an accurate molecular count in milliseconds.
-
product
Dilution-Extractive System
ML675
The Teledyne ML®675 dilution-extractive system can be used in 40CFR75, 40CFR60, 40CFR63, and process control applications. In this system, sample is prepared for analysis by diluting stack gas with clean, dry instrument air at the probe location. Since no moisture is removed with dilution, measurements for SO2, NOx, CO, THC and CO2 are made on a wet basis.
