Filter Results By:
Products
Applications
Manufacturers
D-Sub
D-Subminature Connector AKA: DSub
- Virginia Panel Corporation
product
Cable Assembly, Receiver, QuadraPaddle, 20", 2 50-Pin Female D-Subs
540111040140
Cable Assembly, Receiver, QuadraPaddle, 20", 2 50-Pin Female D-Subs.
-
product
Cable Assembly, Receiver, TriPaddle, 20", 37-Pin Female D-sub and 4 POS Micro Fit Connector
540016070101
Cable Assembly, Receiver, TriPaddle, 20", 37-Pin Female D-sub and 4 POS Micro Fit Connector.
-
product
Two Channel Cable
CONV1553-6
Two channels of dual-redundant 1553. Transitions from each SCSI-2 connector on a VME, VXI or CEI-600-6 front panel to four 18" cables with CJ70 Twinax, 3 lug, 1553 cable jack ends, and D-Sub 9 pin connector for additional I/O.
-
-
product
Cable
RCONQPMC-2
RCONQPMC-2 - Transitions from a SCSI-68 pin connector to four CJ70 Twinax, 3 lug, 1553 cable jack ends and one D-Sub 50 pin connector for additional I/O.
-
product
Keysight 20-Channel 5A Form A Switch for 34980A
34938A
The Keysight 34938A is a high power general-purpose switch module for the 34980A Multifunction Switch/Measure Unit. It has 20 independent single-pole, single-throw (SPST) 5A relays. This module is used to cycle power to products under test, control indicator and status lights, and to actuate external power relays and solenoids. Its 30VDC/250VAC, 5A contacts can handle up to 150W on a single channel, enough for many power line switching applications. Standard 50-pin Dsub connectors allow for use with standard cables, terminal blocks, or mass interconnect solutions.
-
product
CB-37FH, DIN-Rail Horizontal Mount 37-Pin Spring TB
778676-01
37-Pin Female D-SUB to 37-Pin Female Connector, Horizontal DIN-Rail Terminal Block - The CB-37FH is an unshielded terminal block that provides access to NI data acquisition devices with 37-pin female D-SUB connectors. The CB-37FH mounts in line with the DIN rail, and it featuresscrew or spring terminals for connecting to 37 I/O signals, 12 to 30 AWG.
-
product
Cable Assembly, Receiver, 36", TriPaddle, to 37 Pin Female D-Sub
540016020203
Cable Assembly, Receiver, 36", TriPaddle, to 37 Pin Female D-Sub
-
product
Cable Assembly, Receiver, TriPaddle, 20", 2 9-Pin D-Subs
540041020101
Cable Assembly, Receiver, TriPaddle, 20", 2 9-Pin D-Subs.
-
product
R6868, Low-Cost, Unshielded Ribbon Cable, 0.25 m
182482-0R25
68-Pin Female to 68-Pin Female, 1 Ribbon Connection Ribbon Cable - The R68F-68F Cable, sometimes referred to as the R68-68 or RC68-68, is a flat ribbon cable that connects to 68-pin NI data acquisition or digital I/O devices. The R68F-68F Cable is offered in different lengths and with D-SUB or VHDCI front end connectors.
-
product
Cable Assembly, Receiver, TriPaddle, 36", 78-Pin Female D-Sub
540034010203
Cable Assembly, Receiver, TriPaddle, 36", 78-Pin Female D-Sub
-
product
Cable Assembly, Receiver, 72", QuadraPaddle, 78-Pin ML D-Sub
540116020540
Cable Assembly, Receiver, 72", QuadraPaddle, 78-Pin ML D-Sub.
-
product
Solder Cup Connector Kit
Y1140A
Used to build custom cables for 34922, 34924 – 78-pin Dsub female – 60 V
-
product
Cable Assembly, Receiver, 20", QuadraPaddle to 2 x 78-Pin Female D-Sub Connectors
540112050140
Cable Assembly, Receiver, 20", QuadraPaddle to 2 x 78-Pin Female D-Sub Connectors
-
product
Cable Assembly, Receiver, QuadraPaddle, 36", 2 78-Pin Female D-Sub
540034010229
Cable Assembly, Receiver, QuadraPaddle, 36", 2 78-Pin Female D-Sub
-
product
Cable
RCONQPMC-4
RCONQPMC-4 - Transitions from a SCSI-68 pin connector to eight CJ70 Twinax, 3 lug, 1553 cable jack ends and one D-Sub 50 pin connector for additional I/O.
-
product
1' Harness, 78-Pin Male D-Sub Connector
GT97104
1' harness, 78-pin male D-sub connector on both ends
-
product
Cable Assembly, Receiver, 72", TriPaddle, 50 Pin FML D-Sub
540111020503
Cable Assembly, Receiver, 72", TriPaddle, 50 Pin FML D-Sub.
-
product
SHDE9F-DE9F-FX Flexray Cable, No Termination, 1M
198290-01
9-Pin, Female D-SUB to 9-Pin, Female D-SUB FlexRay Cable - The SHD9F-D9F FlexRay Cable connects FlexRay interfaces to devices, breakout boxes, other interfaces, and accessories. This cable meets FlexRay cabling specifications and is compatible with all NI-XNET FlexRay interfaces. It offers 82 dB/km attenuation with no termination. The cable’s impedance is 100 Ω, 148.94 Ω/km at 20 °C resistance, and 5.2 ns/m delay. The cable features four 26 AWG twisted pairs and dedicated pairs for FlexRay Bus A and Bus B.
-
product
Cable Assembly, Receiver, TriPaddle, 36", 37-Pin Female D-Sub
540016050201
Cable Assembly, Receiver, TriPaddle, 36", 37-Pin Female D-Sub
-
product
3' Harness, 50-Pin Male D-Sub Connector
GT97109
3' harness, 50-pin male D-sub connector on both ends.
-
product
SH68-68-D1, Shielded Cable, 0.4 m
183432-0R4
68-Pin, Female D-SUB to 68-Pin, Female D-SUB, Twisted Pair, Shielded Digital Cable - The SH68-68-D1 Digital Cable connects NI 6533/4 digital instruments and NI 660x or 661x counter/timer modules to 68-pin accessories. This shielded cable features twisted pairing and is offered in different lengths.
-
product
3U CompactPCI Serial 2-Port CAN From PEAK Module
cPCI-A3CAN
- Follow PICMG® CompactPCI® Serial design guide- CompactPCI® Serial, 3U 4HP- 2x D-Sub CAN ports in front panel- Operating temperature: -40°C to +85°C- Designed to meet EN50155 standards
-
product
Cable Assembly, Receiver, 36", TriPaddle, 37 Pin Female DSub, 1000V
540119030201
Cable Assembly, Receiver, 36", TriPaddle, 37 Pin Female DSub, 1000V.
-
product
Cable Assembly, Receiver, 36", TriPaddle, 15 Pin FML DSub, 9 Pin FML DSub
540214010201
Cable Assembly, Receiver, 36", TriPaddle, 15 Pin FML DSub, 9 Pin FML DSub.
-
product
SH25M-10F Cable, 25-Pin Male D-SUB to 10-Pin Female COMBICON, Shielded Multifunction Cable
190654-01
25-Pin Male D-SUB to 10-Pin Female COMBICON, Shielded Multifunction Cable - The SH25M-10F Cable, sometimes referred to as SH10F-25M, connects C Series DAQ devices with a 10-pin screw terminal to a 25-pin D-SUB. The SH25M-10F Cable is offered in different lengths.
-
product
Micro Dsub GPIB Cable Adapter For PZ2100A (0.25m)
The Keysight PX0110A converts MicroD25 GPIB to standard GPIB. It supports the Keysight PZ2100A.Standard GPIB to MicroD25 Cable length: 0.25 meter Compatible with the PZ2100A
-
product
USB/RS232/SPI Programmable Attenuator
RUDAT-13G-90
Mini-Circuits’ RUDAT-13G-90 is a general purpose programmable RF attenuator supporting frequencies from 10 to 13000 MHz with attenuation from 0 to 90 dB in 0.5 dB steps. Its unique design maintains linear attenuation change per dB, even at the highest attenuation and frequency settings. The attenuator is controlled via USB, RS232 or SPI. It comes housed in a compact, shielded metal case with SMA(F) input/ output RF ports (RF ports are interchangeable), a USB type Mini-B socket, and a 9-pin D-sub(F) RS232 and SPI port. Power can be supplied via either USB or the D-sub port. The RUDAT-13G-90 is supplied with our easy-to-install, user-friendly GUI software, API objects for Windows® environments, and complete programming instructions for 32 and 64 bit Windows® and Linux® operating systems. See p. 9 for a complete list of included accessories.
-
product
15' Cable, 78-Pin Male Connector On One End, Loose Wired (Numbered) Other End
GT97112
15' harness, 78-pin male D-sub connector on one end, loose wired (numbered) other end.
-
product
CB-37F-LP Unshielded, I/O Connector Block with 37-pin D-Sub
779353-01
37-Pin, Female D-SUB to 40-Pin, Female Screw Terminal, Desktop Mount Terminal Block - The CB-37F-LP is an unshielded terminal block that provides access to DAQ devices with 37-pin connectors. The 37-pin, D-SUB connector makes this connector block ideal for direct mounting on the … DAQ device or connecting through a cable.
-
product
Cable Assembly, Receiver, 20", TriPaddle, to 37 Pin Female D-Sub
540016020103
Cable Assembly, Receiver, 20", TriPaddle, to 37 Pin Female D-Sub
